DIRECT CONNECT MANUAL

DIRECT CONNECT MANUAL How use Direct tie in behind a firewall/router in Active Mode rather of Passive 1. Determine your tired of(p) IP address and your local area network IP address; this can be done both by using winipcfg.exe or ipconfig.exe in my case tone on the status page of my Linksys router configuration. 2.

Now set up DC by going to settings connection and marking the be quiet use Direct Connect in Active Mode, In the force DC to accept connections on this port: I have 412 (Im not sure if this matters yet it has worked for me) you whitethorn urgency to play around with it a bit but I believe it has to be a port in the midst of 375-425 because these are the ports Direct Connect has to have open to move in Active Mode. 3. Check the block force need connect to report this IP and put in the WAN IP address obtained for your situation in Step 1. This completes the apparatus of DC. This bequeath vary slightly for Individual Situations I will explain it for a linksys cable/dsl router but the s...If you want to get a full essay, order it on our website: Ordercustompaper.com

If you want to get a full essay, wisit our page: write my paper